28150
1.REMOVE MAGNET STARTER SWITCH ASSEMBLY
Remove the nut and disconnect the lead wire from terminal C.
Remove the 2 nuts and the magnet starter switch assembly from the starter drive housing assembly.
28120
2.REMOVE STARTER YOKE ASSEMBLY
Using a "TORX" socket wrench T25, remove the 2 through bolts.
Remove the starter yoke assembly and starter cover from the starter drive housing assembly.
28199
3.REMOVE STARTER COVER
Remove the 2 screws.
Remove the starter cover from the starter yoke assembly.
| *1 | Starter Yoke Assembly |
| *2 | Starter Cover |
Hold the lead wire and remove the starter cover.
Remove the dust starter protect from the starter yoke assembly.
28140
4.REMOVE STARTER BRUSH HOLDER ASSEMBLY
Using a screwdriver, disengage the spring from the bush.
Disconnect the 4 brush from the starter brush holder assembly.
Remove the starter brush holder assembly.
28160
5.REMOVE STARTER ARMATURE ASSEMBLY
Pull out the starter armature assembly from the starter yoke assembly.
| *1 | Starter Yoke Assembly |
| *2 | Starter Armature Assembly |
6.REMOVE STARTER ARMATURE PLATE
Remove the starter armature plate from the starter yoke assembly and starter drive housing assembly.
| *1 | Starter Drive Housing Assembly |
| *2 | Starter Yoke Assembly |
| *3 | Starter Armature Plate |
7.REMOVE RUBBER SEAL
Remove the rubber seal from the starter drive housing assembly.
| *1 | Rubber Seal |
8.REMOVE STARTER PLANETARY GEAR
Remove the 3 starter planetary gears from the starter clutch sub-assembly.