Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM
RM2090E _51 Engine / Hybrid System _060673 CRUISE CONTROL _0297540 CRUISE CONTROL SYSTEM C

CRUISE CONTROL  CRUISE CONTROL SYSTEM  U0073  Control Module Communication Bus "A" Off  U0101  Lost Communication with TCM  U0122  Lost Communication with Vehicle Dynamics Control Module  U0155  Lost Communication with Instrument Panel Cluster (IPC) Control Module  U0402  Invalid Data Received from TCM  U0416  Invalid Data Received from Vehicle Dynamics Control Module  U0423  Invalid Data Received from Instrument Panel Cluster Control Module  


DESCRIPTION

The ECM communicates several signals with each sensor and ECU by CAN communication circuit.

There are any malfunctions in the communication circuit, one or more DTCs in the CAN communication system are output.

DTC Code DTC Detection Condition Trouble Area
U0073 Bus off state for 0.436 seconds or more
(1 trip detection logic)
·

Wire harness (CANL and CANH circuits)

·

ECM


U0101 No communication between ECM and TCM for 0.5 seconds or more
(1 trip detection logic)
·

Wire harness (CANL and CANH circuits)

·

TCM

·

ECM


U0122 No communication between ECM and skid control ECU for 0.5 seconds or more
(1 trip detection logic)
·

Wire harness (CANL and CANH circuits)

·

Skid control ECU (Brake actuator assembly)

·

ECM


U0155 No communication between ECM and combination meter assembly for 0.5 seconds or more
(1 trip detection logic)
·

Wire harness (CANL and CANH circuits)

·

Combination meter assembly

·

ECM


U0402 Invalid data received from TCM for 2 seconds or more
(1 trip detection logic)
·

Wire harness (CANL and CANH circuits)

·

TCM

·

ECM


U0416 Invalid data received from skid control ECU for 2 seconds or more
(1 trip detection logic)
·

Wire harness (CANL and CANH circuits)

·

Skid control ECU (Brake actuator assembly)

·

ECM


U0423 Invalid data received from combination meter assembly for 2 seconds or more
(1 trip detection logic)
·

Wire harness (CANL and CANH circuits)

·

Combination meter assembly

·

ECM



PROCEDURE

1.CHECK ANY OTHER DTCS OUTPUT
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Cruise Control / Trouble Codes.


e.

Read the DTCs.

Result:
Result Proceed to
DTC U0073, U0101, U0122, U0155, U0402, U0416 or U0423 is output A
DTC U0073, U0101, U0122, U0155, U0402, U0416 or U0423 and other DTCs are output B




A

B