Home › Drivetrain › TX6A (AUTOMATIC TRANSMISSION / TRANSAXLE) › TRANSMISSION WIRE
RM2090E _52 Drivetrain _060674 TX6A AUTOMATIC TRANSMISSION / TRANSAXLE _0297544 TRANSMISSION WIRE G

TX6A AUTOMATIC TRANSMISSION / TRANSAXLE  TRANSMISSION WIRE  INSPECTION  


PROCEDURE

Hide 82125 1.INSPECT ATF TEMPERATURE SENSOR (TRANSMISSION WIRE)

a.
C214326E93
2.156,1.302 1.958,1.75 true 2.24,1.063 2.5,1.729 true 1.781,1.781 2.104,1.948 0.323,0.167 10 false OIL 0.083,0.073 0.313,0.24 0.229,0.167 10 false *a 2.458,1.74 2.74,1.906 0.281,0.167 10 false E2

Measure the resistance according to the value(s) in the table below.

Text in Illustration
*a Component without harness connected
(ATF Temperature Sensor (Transmission Wire))

Standard Resistance:
Tester Connection Condition Specified Condition
1 (E2) - 9 (OIL) Always 79 Ω to 156 kΩ
1 (E2) - Body ground Always 10 kΩ or higher
9 (OIL) - Body ground Always 10 kΩ or higher


HINT:

If the resistance is out of the specified range at any of the ATF temperatures shown in the table below, the driveability of the vehicle may decrease.


Standard Resistance:
ATF Temperature Specified Condition
10°C (50°F) 5 to 8 kΩ
25°C (77°F) 2.5 to 4.5 kΩ
110°C (230°F) 0.22 to 0.28 kΩ


If the result is not as specified, replace the ATF temperature sensor (transmission wire).