Home › Drivetrain › TX6A (AUTOMATIC TRANSMISSION / TRANSAXLE) › PARK / NEUTRAL POSITION SWITCH
RM2090E _52 Drivetrain _060674 TX6A AUTOMATIC TRANSMISSION / TRANSAXLE _0297546 PARK / NEUTRAL POSITION SWITCH N

TX6A AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  ADJUSTMENT  


PROCEDURE

Hide 35572 1.DISCONNECT TRANSMISSION CONTROL SHAFT LEVER RH

a.

While pushing the shift lock release button, move the shift lever to N.


b.
C260608

Remove the nut and spring washer, and disconnect the transmission control shaft lever RH.


Hide 84540 2.ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.
U147221

Remove the bolt of the park/neutral position switch assembly.


b.

Clean the bolt and the bolt hole.


c.
A057108E68
2.156,0.26 2.031,0.26 2.031,0.26 1.75,1.292 false 2.198,0.156 2.375,0.323 0.177,0.167 10 false *1

Apply adhesive to 2 or 3 threads on the end of the bolt.

Text in Illustration
*1 Adhesive

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent



d.
U118093E19
1.969,0.896 2.813,0.896 true 1.99,1.563 2.802,1.563 true 1.969,0.563 1.969,1.188 false 2.833,0.802 3,0.958 0.167,0.156 10 false *a 2.833,1.458 3,1.615 0.167,0.156 10 false *b

Align the neutral basic line with the groove as shown in the illustration.

Text in Illustration
*a Neutral Basic Line
*b Groove


e.

Hold the park/neutral position switch assembly in position and install the bolt.

Torque:
13 N*m (130 kgf*cm, 9 ft.*lbf)


Hide 35572 3.CONNECT TRANSMISSION CONTROL SHAFT LEVER RH

a.

Connect the transmission control shaft lever RH with the spring washer and nut.

Torque:
16 N*m (160 kgf*cm, 12 ft.*lbf)