Home › Drivetrain › TX6A (AUTOMATIC TRANSMISSION / TRANSAXLE) › SHIFT LEVER
RM2090E _52 Drivetrain _060674 TX6A AUTOMATIC TRANSMISSION / TRANSAXLE _0297548 SHIFT LEVER G

TX6A AUTOMATIC TRANSMISSION / TRANSAXLE  SHIFT LEVER  INSPECTION  


PROCEDURE

Hide 1.INSPECT TRANSMISSION CONTROL SWITCH (SHIFT LEVER ASSEMBLY)

a.
A280138E01
0.339,0.272 0.513,0.443 0.174,0.171 10 *a

Measure the resistance according to the value(s) in the table below.

Text in Illustration
*a Component without harness connected
(Transmission Control Switch (Shift Lever Assembly))

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 3 Shift lever not in P Below 1 Ω
2 - 3 Shift lever in P
8 - 9 Shift lever in M
Shift lever held in "+"
(Up shift)
10 - 11 Shift lever in M
12 - 13 Shift lever in M
Shift lever held in "-"
(Down shift)
1 - 3 Shift lever in P 10 kΩ or higher
2 - 3 Shift lever not in P
8 - 9 Shift lever in M
Shift lever not in "+"
10 - 11 Shift lever not in M
12 - 13 Shift lever in M
Shift lever not in "-"


If the result is not as specified, replace the transmission control switch.


Hide 33560 2.INSPECT SHIFT LOCK CONTROL UNIT ASSEMBLY (SHIFT LEVER ASSEMBLY)

a.
A280138E01
0.339,0.272 0.513,0.443 0.174,0.171 10 *a

Measure the resistance according to the value(s) in the table below.

Text in Illustration
*a Component without harness connected
(Shift Lock Control Unit Assembly)

Standard Resistance:
Tester Connection Condition Specified Condition
4 - 5 20°C (68°F) 27.6 to 30.5 Ω


If the result is not as specified, replace the shift lock control unit assembly.