Home › Drivetrain › TX6A (AUTOMATIC TRANSMISSION / TRANSAXLE) › SHIFT LEVER
RM2090E _52 Drivetrain _060674 TX6A AUTOMATIC TRANSMISSION / TRANSAXLE _0297548 SHIFT LEVER A

TX6A AUTOMATIC TRANSMISSION / TRANSAXLE  SHIFT LEVER  DISASSEMBLY  


PROCEDURE

Hide 33521Q 1.REMOVE FLOOR SHIFT SHIFT LEVER HOUSING

a.
C260593

Using a screw driver, disengage the claw and disconnect the connector.


b.
C261653

Using a thin-bladed screwdriver, lift up the terminal retainer of the transmission control switch connector to release the lock.


c.
C260594

Using a thin-bladed screwdriver, pull out terminals 2, 3, 10 and 11 of the transmission control switch connector.


d.
C260595

Remove the shift lever lock nut and shift lever lock pin.


e.
C260596

Disengage the 2 claws and remove the floor shift shift lever housing from the base plate.


Hide 33560 2.REMOVE SHIFT LOCK CONTROL UNIT ASSEMBLY

C260600

a.

Remove the pin then remove the shift lock release arm and shift lock control unit assembly.


b.

Remove the shift lock release arm from the shift lock control unit assembly.


Hide 33631 3.REMOVE DETENT ROD

C262067

a.

Remove the detent lock clamp.


b.

Remove the detent lock spring and detent lock rod.


c.

Remove the cushion detent lock from the detent lock rod.


d.

Remove the bush detent lock.


Hide 33502B 4.REMOVE SHIFT LEVER PLATE GROMMET

a.
C260605

Remove the shift lever plate grommet from the base plate.


Hide 33711F 5.REMOVE FLOOR SHIFT CONTROL SHAFT LEVER

a.
C260602

Using a pin punch (3 mm (0.118 in.)) and a hammer, drive out the spring pin.


b.
C261899

Remove the floor shift control shaft lever from the base plate.


Hide 33535F 6.REMOVE FLOOR SHIFT CONTROL SELECT LEVER

a.
C261900

Remove the floor shift support bracket and the floor shift control shaft lever from the base plate.


Hide 33576B 7.REMOVE FLOOR SHIFT SUPPORT BRACKET

a.
C261901

Remove the floor shift support bracket from the floor shift control shaft lever.


b.
C262079

Remove the pin and the spring from the floor shift support bracket.


Hide 33505B 8.REMOVE SHIFT LEVER SEAT SUB-ASSEMBLY

a.
C260606

Remove the 4 spacer plates and shift lever seat sub-assembly from the base plate.


Hide 33723F 9.REMOVE FLOOR SHIFT CONNECTING ROD SWIVEL

a.
C260604

Remove the clip, 2 washers, grommet, pin and floor shift connecting rod swivel from the select lever.