Home › Drivetrain › TX6A (AUTOMATIC TRANSMISSION / TRANSAXLE) › SHIFT LEVER
RM2090E _52 Drivetrain _060674 TX6A AUTOMATIC TRANSMISSION / TRANSAXLE _0297548 SHIFT LEVER A

TX6A AUTOMATIC TRANSMISSION / TRANSAXLE  SHIFT LEVER  REASSEMBLY  


PROCEDURE

Hide 33723F 1.INSTALL FLOOR SHIFT CONNECTING ROD SWIVEL

a.
C260604

Install the 2 washers, grommet, pin and floor shift connecting rod swivel to the select lever with the clip.


Hide 33505B 2.INSTALL SHIFT LEVER SEAT SUB-ASSEMBLY

a.
C260606

Install the shift lever seat sub-assembly and the 4 spacer plates to the base plate.


Hide 33576B 3.INSTALL FLOOR SHIFT SUPPORT BRACKET

a.
C262082

Apply MP grease to the spring and pin.


b.

Install the spring and pin to the floor shift support bracket.


c.
C257559

Apply MP grease to the floor shift control shaft lever and floor shift support bracket.


d.
C262091

Install the floor shift support bracket to the floor shift control shaft lever.


Hide 33535F 4.INSTALL FLOOR SHIFT CONTROL SELECT LEVER

a.
C262090

Install the floor shift support bracket and floor shift control shaft lever to the base plate.


Hide 33711F 5.INSTALL FLOOR SHIFT CONTROL SHAFT LEVER

a.
C262089

Install the floor shift control shaft lever to the base plate.


b.
C262080

Using a pin punch (3 mm (0.118 in.)) and a hammer, install a new spring pin.


Hide 33502B 6.INSTALL SHIFT LEVER PLATE GROMMET

a.
C260605

Install the shift lever plate grommet to the base plate.


Hide 33631 7.INSTALL DETENT ROD

C262067

a.

Install the bush detent lock.


b.

Install the cushion detent lock to the detent lock rod.


c.

Apply MP grease to the detent lock spring and detent lock rod.


d.

Install the detent lock rod and detent lock spring.


e.

Install the detent lock clamp.


Hide 33560 8.INSTALL SHIFT LOCK CONTROL UNIT ASSEMBLY

C262078

a.

Apply MP grease to the pin.


b.

Install the shift lock release arm to the shift lock control unit assembly.


c.

Install the shift lock control unit assembly to the base plate.


Hide 33521Q 9.INSTALL FLOOR SHIFT SHIFT LEVER HOUSING

a.
C260596

Engage the 2 claws and install the floor shift shift lever housing to the base plate.


b.
C262077

Install the shift lever lock nut and shift lever lock pin.


c.
C262081

Install the terminals 2, 3, 10 and 11 of the transmission control switch connector.


d.
C262088

Lock the harness connector terminals.


e.
C257572

Engage the claw and install the connector.