84610F
1.INSPECT SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected
(Shift Paddle Switch (transmission shift switch assembly)) |
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 - 3 | Pull continuously "+"
(Up shift) |
Below 1 Ω |
| Release "+" | 10 Ω or higher | |
| 1 - 4 | Pull continuously "-"
(Down shift) |
Below 1 Ω |
| Release "-" | 10 Ω or higher |
If the resistance value are not as specified, replace the shift paddle switch (transmission shift switch assembly).