Home › Drivetrain › TX6A (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSMISSION SYSTEM
RM2090E _52 Drivetrain _060674 TX6A AUTOMATIC TRANSMISSION / TRANSAXLE _0297556 AUTOMATIC TRANSMISSION SYSTEM D

TX6A AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM  DTC CHECK / CLEAR  


NOTICE:

When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and freeze frame data recorded in normal mode are cleared. Before changing modes, always check and make a note of DTCs and freeze frame data.


HINT:
·

DTCs which are stored in the ECM can be displayed on the GTS. The GTS can display the current, pending and permanent DTCs.

·

If a malfunction is detected during the current driving cycle, current and permanent DTCs are stored.

·

Some DTCs are not stored if the ECM does not detect the same malfunction again during a second consecutive driving cycle. However, such malfunctions, detected on only one occasion, are stored as pending DTCs.

·

Current and pending DTCs can be cleared by using the GTS. However, permanent DTCs cannot be cleared using either of these two methods.

·

After clearing current DTCs using the GTS, permanent DTCs can be cleared when the system is determined to be normal for the relevant DTCs and then the universal trip is performed.


2 Trip Detection Examples
Pending DTC Store condition Malfunction detected
Clear condition System determined to be normal
or
DTCs cleared using GTS
or
Cable disconnected from negative battery terminal
Current DTC Store condition Malfunction detected (2nd trip)
Clear condition No malfunctions in 40 driving cycles
or
DTCs cleared using GTS
Permanent DTC Store condition Malfunction detected (2nd trip)
Clear condition One trip is confirmed with no abnormality after no malfunction is detected in 3 consecutive driving cycles
or
After DTCs cleared using GTS, malfunction not detected when universal trip driving performed
MIL ON Malfunction detected (2nd trip)
OFF One trip is confirmed with no abnormality after no malfunction is detected in 3 consecutive driving cycles
or
DTCs cleared using GTS


A198847E02
0.063,0.052 1.823,0.229 1.76,0.177 10 2 Trip Detection Examples 0.042,1.094 0.323,1.292 0.281,0.198 10 Trip 0.042,1.656 1.365,1.896 1.323,0.24 10 Pending DTC Status 0.042,2.25 1.323,2.417 1.281,0.167 10 Current DTC Status 0.042,2.958 0.781,3.125 0.74,0.167 10 MIL Status 0.042,3.635 1.531,3.802 1.49,0.167 10 Permanent DTC Status 1.531,0.333 1.917,0.521 0.385,0.188 10 1 Trip 2.365,0.333 2.75,0.521 0.385,0.188 10 2 Trip 3.208,0.333 3.594,0.521 0.385,0.188 10 3 Trip 4.052,0.333 4.438,0.521 0.385,0.188 10 4 Trip 4.896,0.333 5.281,0.521 0.385,0.188 10 5 Trip 5.729,0.333 6.115,0.521 0.385,0.188 10 6 Trip 6.542,0.333 7,0.521 0.458,0.188 10 43 Trip 0.708,0.969 1.156,1.146 0.448,0.177 10 Driving 0.708,1.302 1.135,1.469 0.427,0.167 10 IG off 0.354,4.083 1.823,4.271 1.469,0.188 10 : Malfunction detected 0.354,4.406 2.042,4.594 1.688,0.188 10 : Malfunction not detected 1.75,1.75 2.073,1.979 0.323,0.229 10 ON 1.365,2.104 1.698,2.333 0.333,0.229 10 OFF 2.573,2.354 2.885,2.563 0.313,0.208 10 ON 2.219,2.698 2.563,2.948 0.344,0.25 10 OFF 2.573,3 2.854,3.219 0.281,0.219 10 ON 2.24,3.365 2.563,3.615 0.323,0.25 10 OFF 2.573,3.677 2.854,3.896 0.281,0.219 10 ON 2.219,4.021 2.531,4.198 0.313,0.177 10 OFF

C266991E01
0.044,0 6.676,0.331 6.632,0.331 10 2 Trip Detection Examples (Instance when DTCs were cleared midway through by using the GTS) 0.034,1.207 0.315,1.401 0.281,0.194 10 Trip 0.034,1.877 1.350,2.047 1.316,0.170 10 Pending DTC Status 0.034,2.508 1.306,2.678 1.272,0.170 10 Current DTC Status 0.034,3.166 0.750,3.336 0.716,0.170 10 MIL Status 0.034,3.818 1.528,3.988 1.494,0.170 10 Permanent DTC Status 2.024,0.639 2.411,0.813 0.387,0.174 10 1 Trip 2.984,0.639 3.372,0.813 0.387,0.174 10 2 Trip 3.949,0.639 4.336,0.813 0.387,0.174 10 3 Trip 4.925,0.639 5.313,0.813 0.387,0.174 10 4 Trip 1.09,1.204 1.552,1.379 0.461,0.174 10 Driving 1.09,1.546 1.552,1.720 0.461,0.174 10 IG off 0.328,5.35 1.919,5.515 1.591,0.165 10 : Universal trip performed 5.465,0.521 6.779,0.686 1.313,0.165 10 Universal trip driving 2.208,1.954 2.475,2.110 0.267,0.156 10 ON 1.879,2.312 2.191,2.464 0.312,0.152 10 OFF 3.175,2.578 3.442,2.734 0.267,0.156 10 ON 2.846,2.935 3.158,3.088 0.312,0.152 10 OFF 3.175,3.235 3.442,3.391 0.267,0.156 10 ON 2.846,3.593 3.158,3.745 0.312,0.152 10 OFF 3.175,3.895 3.442,4.051 0.267,0.156 10 ON 2.846,4.252 3.158,4.405 0.312,0.152 10 OFF 0.328,4.333 1.743,4.512 1.415,0.179 10 : Malfunction detected 0.328,4.672 4.864,4.835 4.536,0.163 10 : After problem areas repaired and DTCs cleared, DTC check performed 0.328,5.009 2.007,5.178 1.679,0.170 10 : Malfunction not detected

CHECK DTC


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch ON.


c.

Turn the GTS on.


d.

Enter the following menus: "Powertrain / ECT / Trouble Codes" or "Body Electrical / Main Body / Trouble Codes".


e.

Check the DTC(s) and freeze frame data, and then write them down.




CLEAR DTC (Pending and Current DTC)


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch ON.


c.

Turn the GTS on.


d.

Enter the following menus: "Powertrain / ECT / Trouble Codes" or "Body Electrical / Main Body / Trouble Codes".


e.

Clear the DTCs.



CLEAR PERMANENT DTC


HINT:

Even if the following procedure is not performed, permanent DTCs are cleared if no malfunction are detected during 3 consecutive driving cycles.


C369198E01
0.073,0.063 1.865,0.281 1.792,0.219 10 false Universal Trip Driving Pattern 3.26,0.438 5.052,0.656 1.792,0.219 10 false Total of 5 minutes or more 0.542,1.135 1.667,1.365 1.125,0.229 10 false 40 km/h (25 mph) 1.26,2.344 1.646,2.563 0.385,0.219 10 false Idling 0.448,2.646 1.656,2.865 1.208,0.219 10 false Ignition Switch ON 0.458,2.958 1.667,3.177 1.208,0.219 10 false Ignition Switch OFF 2.104,2.667 3.396,2.875 1.292,0.208 10 false 30 seconds or more 3.24,3.208 4.531,3.417 1.292,0.208 10 false 10 minutes or more 4.99,3.396 6.417,3.583 1.427,0.188 10 false Permanent DTC Clear

a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / ECT / Trouble Codes.


e.

Check if permanent DTCs are stored.

HINT:

If permanent DTCs are not output, it is not necessary to continue this procedure.



f.

Clear DTCs.


g.

Perform the universal trip.

1.

Idle the engine for 30 seconds or more.

2.

Drive the vehicle at 40 km/h (25 mph) or more for a total of 5 minutes or more.

HINT:
·

It is possible to complete the drive pattern even if the vehicle decelerates to less than 40 km/h (25 mph) during the driving cycle provided that the vehicle is driven at 40 km/h (25 mph) or more for a total of 5 minutes.

·

When accelerating through the gears, make sure the vehicle is driven so all gears are used in order and no gears are skipped.



3.

Allow 10 minutes or more to elapse from the time the engine is started.



h.

Turn the ignition switch off.


i.

Wait 15 seconds.


j.

Turn the ignition switch ON.


k.

Enter the following menus: Powertrain / ECT / Trouble Codes.


l.

Check that the permanent DTCs have been cleared.

HINT:
·

If the permanent DTCs have not been cleared, perform the universal trip again.

·

The permanent DTCs are cleared when the universal trip is completed.