Home › Drivetrain › TX6A (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSMISSION SYSTEM
RM2090E _52 Drivetrain _060674 TX6A AUTOMATIC TRANSMISSION / TRANSAXLE _0297556 AUTOMATIC TRANSMISSION SYSTEM D

TX6A AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM  MONITOR DRIVE PATTERN  


MONITOR DRIVE PATTERN FOR ECT TEST


a.

Perform this drive pattern as one method to simulate the detection conditions of the ECT malfunctions. (The DTCs may not be detected due the actual driving conditions. And some codes may not be detected through this drive pattern.)

HINT:

Preparation for driving

·

Warm up the engine sufficiently. (Engine coolant temperature is 60°C (140°F) or higher)


Notice in driving

·

Drive the vehicle through all gears.

Stop → 1st → 2nd → 3rd → 4th → 5th → 6th → 6th (lock-up ON).

·

Perform engine brake test in the M position.

While driving in the 6(M) position and 6th gear lock-up, shift into the "-" position and down-shift from 6th to 5th, 5th to 4th, 4th to 3rd, 3rd to 2nd, 2nd to 1st.

Check that the engine brake performs properly whenever down-shift takes place.

·

Repeat the above driving pattern three times or more.



NOTICE:
·

The monitor status can be checked using GTS. When using GTS, monitor status can be found in the "Powertrain / ECT / Data List".

·

In the event that the drive pattern must be interrupted (possibly due to traffic conditions or other factors), the drive pattern can be resumed and, in most cases, the monitor can be completed.

·

Perform this drive pattern on a level road as much as possible and strictly observe the posted speed limits and traffic laws while driving.



C368925E01
0.583,0.094 1.531,0.292 0.948,0.198 10 false Vehicle Speed 1.281,0.333 5.719,0.698 4.438,0.365 10 false Maintain a constant speed or gradual acceleration (with the throttle open) for 3 minutes or more.*1 0.021,1.031 1.063,1.385 1.042,0.354 10 false Approx. 100km/h (62mph) 0.031,1.906 1.073,2.26 1.042,0.354 10 false Approx. 80 km/h (50mph) 0.885,3.177 1.01,3.375 0.125,0.198 10 false 0 5,1.042 6.042,1.396 1.042,0.354 10 false Lock-up ON Vehicle Speed 3.594,3.531 4.427,3.75 0.833,0.219 10 false Stop (Idling) 1.469,3.698 3.604,4.083 2.135,0.385 10 false Normal acceleration through all the gears from 1st to 6th 0.458,3.458 1.26,3.844 0.802,0.385 10 false Warmed up sufficiently

HINT:

*1: Drive at such a speed in the uppermost gear, to engage lock-up. The vehicle can be driven at a speed lower than that in the above diagram under the lock-up condition.