89650
1.REMOVE POWER STEERING ECU ASSEMBLY
2.SEPARATE STEERING INTERMEDIATE SHAFT ASSEMBLY
Put matchmarks on the steering intermediate shaft assembly and the steering column assembly.
| *a | Matchmark |
Remove the bolt and separate the steering intermediate shaft assembly from the steering column assembly.
55107A
3.REMOVE CLUTCH PEDAL SUPPORT SUB-ASSEMBLY
Disconnect the 3 connectors.
Disconnect the connector and wire harness clamp.
Remove the clip and the clevis pin, and separate the clutch master cylinder push rod clevis from the clutch pedal lever sub-assembly.
Remove the clip and push rod pin, and separate the brake master cylinder push rod clevis from the brake pedal.
Remove the 2 nuts and separate the clutch master cylinder assembly.
Remove the 3 bolts, 4 nuts and the clutch pedal support sub-assembly.
|
Bolt |
|
Nut |
84520
4.REMOVE CLUTCH START SWITCH ASSEMBLY
88280A
5.REMOVE CLUTCH SWITCH ASSEMBLY
Remove the nut and the clutch switch assembly from the clutch pedal support sub-assembly.
31301A
6.REMOVE CLUTCH PEDAL SPRING
Remove the 2 E-rings and the 2 clevis pins.
Remove the assist rod A, assist rod B, clutch pedal spring and assist bush.
Remove the 2 bushes from the clutch pedal sub-assembly and clutch pedal support sub-assembly.
31301
7.REMOVE CLUTCH PEDAL SUB-ASSEMBLY
Using a pin punch (3 mm (0.118 in.)) and a hammer, tap out the straight pin and remove the clutch pedal lever sub-assembly.
Remove the clutch pedal sub-assembly and 2 clutch pedal bushes from the clutch pedal support sub-assembly.
31322
8.REMOVE CLUTCH PEDAL STOPPER
Remove the clutch pedal stopper from the clutch pedal support sub-assembly.
31301B
9.REMOVE NO. 1 CLUTCH PEDAL CUSHION
Remove the No. 1 clutch pedal cushion from the clutch pedal sub-assembly.
31321
10.REMOVE CLUTCH PEDAL PAD
Remove the clutch pedal pad from the clutch pedal sub-assembly.