Home › Drivetrain › CLUTCH › CLUTCH MASTER CYLINDER(for LHD)
RM2090E _52 Drivetrain _060675 CLUTCH _0297562 CLUTCH MASTER CYLINDER(for LHD) A

CLUTCH  CLUTCH MASTER CYLINDER(for LHD)  DISASSEMBLY  


PROCEDURE

Hide 47202 1.REMOVE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY

a.

Remove the master cylinder reservoir cap.


b.

Fix the clutch master cylinder assembly in a vise between aluminum plates.

NOTICE:

Do not overtighten the vise.



c.

Using a pin punch and a hammer, tap out the straight pin and remove the master cylinder body.


Hide 31417 2.REMOVE CLUTCH RESERVOIR GROMMET

a.

Remove the clutch reservoir grommet from the clutch master cylinder assembly.


Hide 31415B 3.REMOVE MASTER CYLINDER PISTON SUB-ASSEMBLY

C261656

a.

Using snap ring pliers, remove the snap ring while pushing the clutch master cylinder push rod.


b.

Remove the master cylinder piston sub-assembly and spring from the master cylinder body.

NOTICE:

Do not damage the inside of the master cylinder body.