Home › Drivetrain › CLUTCH › CLUTCH MASTER CYLINDER(for RHD)
RM2090E _52 Drivetrain _060675 CLUTCH _0297563 CLUTCH MASTER CYLINDER(for RHD) A

CLUTCH  CLUTCH MASTER CYLINDER(for RHD)  DISASSEMBLY  


PROCEDURE

Hide 1.REMOVE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY

a.

Remove the master cylinder reservoir cap.


b.

Fix the clutch master cylinder assembly in a vise between aluminum plates.

NOTICE:

Do not overtighten the vise.



c.

Using a pin punch and a hammer, tap out the straight pin and remove the master cylinder reservoir sub-assembly.


Hide 31417 2.REMOVE CLUTCH RESERVOIR GROMMET

a.

Remove the clutch reservoir grommet from the clutch master cylinder assembly.


Hide 3.REMOVE MASTER CYLINDER PISTON SUB-ASSEMBLY

C261656

a.

Using snap ring pliers, remove the snap ring while pushing the clutch master cylinder push rod.


b.

Remove the master cylinder piston sub-assembly and spring from the cylinder body.

NOTICE:

Do not damage the inside of the cylinder body.