88280A
1.INSTALL CLUTCH SWITCH ASSEMBLY
Install the clutch switch assembly to the clutch pedal support sub-assembly with the nut.
Connect the clutch switch connector.
Without depressing the clutch pedal, check that there is no clearance between the switch shaft and the clutch pedal stopper.
| *a | No Clearance |
Do not turn the clutch switch assembly.
84520
2.INSTALL CLUTCH START SWITCH ASSEMBLY
Install the clutch start switch assembly to the clutch pedal support sub-assembly with the nut.
Connect the clutch start switch connector.
With the clutch pedal fully depressed, check that the clearance shown in the illustration is as specified.
| *a | Clearance |
3.2 to 4.6 mm (0.1260to 0.1811in.)
Do not turn the clutch start switch assembly.
73900
3.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5.INSPECT CLUTCH START SYSTEM