Home › Drivetrain › TL70 (MANUAL TRANSMISSION / TRANSAXLE) › INPUT SHAFT
RM2090E _52 Drivetrain _060676 TL70 MANUAL TRANSMISSION / TRANSAXLE _0297575 INPUT SHAFT G

TL70 MANUAL TRANSMISSION / TRANSAXLE  INPUT SHAFT  INSPECTION  


PROCEDURE

Hide 1.INSPECT NO. 2 SYNCHRONIZER RING

a.
C257058

Apply manual transmission gear oil to the taper corn of the 3rd gear, and hold the No. 2 synchronizer ring in position with your hand to measure the clearance between the No. 2 synchronizer ring and 3rd gear by using a feeler gauge.

Standard clearance:

0.8 to 1.6 mm (0.0315 to 0.0630 in.)


Minimum clearance:

0.8 mm (0.0315 in.)


NOTICE:

Check the entire circumference of the gear.


HINT:

If the clearance is less than the minimum, replace the No. 2 synchronizer ring with a new one.



b.
C257057

Apply manual transmission gear oil to the taper cone of the 3rd gear, and then hold the No. 2 synchronizer ring in position with your hand to check that it does not slide in the circumferential direction.

HINT:

If the No. 2 synchronizer ring slides, replace the No. 2 synchronizer ring with a new one.