Home › Drivetrain › TL70 (MANUAL TRANSMISSION / TRANSAXLE) › INPUT SHAFT
RM2090E _52 Drivetrain _060676 TL70 MANUAL TRANSMISSION / TRANSAXLE _0297575 INPUT SHAFT A

TL70 MANUAL TRANSMISSION / TRANSAXLE  INPUT SHAFT  DISASSEMBLY  


PROCEDURE

Hide 1.INSPECT NEEDLE ROLLER BEARING

a.
C257051

Install the input shaft to the output shaft, and then check the needle roller bearing.

Standard:

Abnormal fitting, interfering, abnormal noise, or looseness should not be found.


HINT:

If any abnormality is found, replace the needle roller bearing with a new one.



Hide 2.INSPECT RADIAL CLEARANCE

a.
C257052

Install the input shaft to the output shaft, and then using a dial indicator, measure the radial clearance.

Standard clearance:

0.029 to 0.072 mm (0.00114 to 0.00283 in.)


Maximum clearance:

0.072 mm (0.00283 in.)


HINT:

If the clearance exceeds the maximum, replace the needle roller bearing and output shaft with a new ones.



Hide 3.INSPECT FRONT INPUT SHAFT BEARING

a.
C257050

Check the front input shaft bearing.

Standard:

Abnormal fitting, interfering, abnormal noise, or looseness should not be found.


HINT:

If any abnormality is found, replace the front input shaft bearing with a new one.



Hide 4.REMOVE NEEDLE ROLLER BEARING

a.
C266542

Remove the needle roller bearing from the input shaft.


Hide 5.REMOVE NO. 2 SYNCHRONIZER RING

a.
C266543

Remove the No. 2 synchronizer ring from the input shaft.


Hide 6.REMOVE FRONT INPUT SHAFT BEARING

a.
C257053

Using 2 screwdrivers and a hammer, remove the shaft snap ring from the input shaft.

NOTICE:

Use a cloth to prevent the shaft snap ring from popping out.



b.
C257054E02
1.885,1.156 2.188,0.854 true 2.219,0.708 2.552,0.927 0.333,0.219 10 false SST

Using SST and a press, remove the front input shaft bearing from the input shaft.

SST
09950-00020