Home › Drivetrain › TL70 (MANUAL TRANSMISSION / TRANSAXLE) › INPUT SHAFT
RM2090E _52 Drivetrain _060676 TL70 MANUAL TRANSMISSION / TRANSAXLE _0297575 INPUT SHAFT A

TL70 MANUAL TRANSMISSION / TRANSAXLE  INPUT SHAFT  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL FRONT INPUT SHAFT BEARING

a.
C266540E02
0.542,0.427 0.333,0.302 true 2.427,0.5 2.771,0.635 2.771,0.635 2.469,0.885 true 0.177,0.208 0.375,0.385 0.198,0.177 10 false *1 2.854,0.552 3.198,0.729 0.344,0.177 10 false SST

Using SST and a press, as shown in the illustration, install a new front input shaft bearing to the input shaft.

Text in Illustration
*1 Front Input Shaft Bearing
V100135

Front Side

SST
09527-20011  
09950-60010  (09951-00560)

NOTICE:

Retain the front input shaft bearing inner race, and press fit.



b.
C257056

Select a shaft snap ring that is suitable to retain the specific thrust clearance between the front input shaft bearing and shaft snap ring.

Standard clearance:

0 mm (0 in.)


Maximum clearance:

0.1 mm (0.00394 in.)


Shaft Snap Ring Thickness
Part No. Thickness mm (in.) Mark
SU003-03575 1.95 (0.07677) 0
SU003-03576 2.00 (0.07874) 1
SU003-03577 2.05 (0.08070) 2
SU003-03578 2.10 (0.08267) 3
SU003-03579 2.15 (0.08464) 4
SU003-03580 2.20 (0.08661) 5


c.

Using a brass bar and a hammer, install a new shaft snap ring to the input shaft.


Hide 2.INSTALL NO. 2 SYNCHRONIZER RING

a.
C266543

Apply manual transmission gear oil to the No. 2 synchronizer ring, and then install the No. 2 synchronizer ring to the input shaft.


Hide 3.INSTALL NEEDLE ROLLER BEARING

a.
C266542

Apply manual transmission gear oil to the needle roller bearing, and then install the needle roller bearing to the input shaft.