Home › Drivetrain › TL70 (MANUAL TRANSMISSION / TRANSAXLE) › SHIFT LEVER ASSEMBLY
RM2090E _52 Drivetrain _060676 TL70 MANUAL TRANSMISSION / TRANSAXLE _0297578 SHIFT LEVER ASSEMBLY N

TL70 MANUAL TRANSMISSION / TRANSAXLE  SHIFT LEVER ASSEMBLY  ADJUSTMENT  


PROCEDURE

Hide 1.ADJUST SHIFT LEVER POSITION

a.
C260584

Loosen the 4 bolts of the shift lever cap. [*1]


b.

Move the shift lever to 2nd. [*2]


c.
C306719E03
1.302,4.198 1.021,4.448 true 2.354,3.604 1.906,3.781 true 1.479,3.958 2.375,4.073 true 0.854,4.385 1.094,4.594 0.24,0.208 10 false *1 2.396,3.5 2.635,3.708 0.24,0.208 10 false *2 2.417,4 2.656,4.208 0.24,0.208 10 false *3 0.875,3.667 1.115,3.875 0.24,0.208 10 false *a

Insert a 1 mm (0.03937 in.) feeler gauge between the stopper and the shift lever cap, and push the shift lever cap against the stopper. [*3]

Text in Illustration
*1 Shift Lever Cap
*2 Stopper
*3 Feeler Gauge
*a 1.0 mm (0.03937 in.)
V100136

Push


d.
C306721E02
0.719,2.063 1.031,2.26 0.313,0.198 10 false *a 2.042,2.073 2.354,2.271 0.313,0.198 10 false *b

While keeping the clearance gap between the stopper and the shift lever cap parallel, tighten the 4 bolts to the specified torque. [*4]

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

NOTICE:

After tightening the bolts, check that there is an equal amount of clearance gap between the stopper and the shift lever cap.


Text in Illustration
*a Correct
*b Incorrect
V100135

Front of vehicle


e.

Depress the clutch pedal and check that the shift lever can be moved to 1st and 2nd.


f.

If the shift lever cannot be moved to 1st and 2nd, repeat steps [*1] to [*4] , decreasing the thickness of the feeler gauge in increments of 0.2 mm (0.00787 in.) until the shift lever can be moved to 1st and 2nd.


g.

Depress the clutch pedal and check that the shift lever can be moved to 1st and 2nd.


h.

After adjusting the position of the shift lever, apply MP grease to the stopper and shift lever cap.