Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY
RM2090E _52 Drivetrain _060677 DRIVE SHAFT / PROPELLER SHAFT _0297582 PROPELLER SHAFT ASSEMBLY G

DRIVE SHAFT / PROPELLER SHAFT  PROPELLER SHAFT ASSEMBLY  INSPECTION  


PROCEDURE

Hide 37100 1.INSPECT PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

a.

Set the dial indicator so that the dial indicator measurement probe is centered on the propeller shaft with center bearing shaft assembly.


b.
C264277

Lightly turn the propeller shaft with center bearing shaft assembly by hand, and measure the deflection.

Maximum runout:

0.6 mm (0.0236 in.)


NOTICE:

The dial indicator must be placed so that it is perpendicular to the propeller shaft with center bearing shaft assembly at the center of the shaft.


If the shaft runout is more than the maximum, replace the propeller shaft with center bearing shaft assembly.


Hide 2.INSPECT SPIDER BEARING

a.
C257540E03
1.76,4.229 1.406,3.854 false 1.979,1.823 1.552,1.552 false 1.771,4.26 1.938,4.417 0.167,0.156 10 false *2 2.01,1.802 2.177,1.958 0.167,0.156 10 false *1

Check that the spider bearing rotates smoothly.


b.

Check that there is no play in the spider bearing.

Text in Illustration
*1 Front Spider Bearing
*2 Rear Spider Bearing


Hide 3.INSPECT CENTER SUPPORT BEARING ASSEMBLY

a.
C260998

Turn the center support bearing assembly by hand. Check that the center support bearing assembly turns smoothly.


b.

Check that the center support bracket of the center support bearing assembly is not cracked or deformed.


c.

Check that the seals are not cracked or damaged.

HINT:

If the center support bearing assembly is damaged or worn, or does not turn smoothly, replace it.