Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER
RM2090E _53 Suspension _060681 REAR SUSPENSION _0297605 REAR SHOCK ABSORBER A

REAR SUSPENSION  REAR SHOCK ABSORBER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

The procedure listed below is for the LH side.

·

Use the same procedure for the RH and LH sides.



PROCEDURE

Hide 64711 1.REMOVE LUGGAGE COMPARTMENT FLOOR MAT

Hide 64722 3.REMOVE LUGGAGE COMPARTMENT TRIM COVER INNER LH

Hide 4.REMOVE REAR WHEEL

Hide 89408C 5.SEPARATE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ HID Headlight System)

a.
C257516

Remove the nut and separate the rear height control sensor sub-assembly LH from the rear No. 2 suspension arm assembly LH.


Hide 48802 6.SEPARATE STABILIZER LINK SUB-ASSEMBLY (for LH Side)

a.
C256612

Remove the bolt, nut and separate the rear stabilizer link sub-assembly from the rear No. 2 suspension arm assembly LH.


Hide 48740F 7.SEPARATE REAR NO. 2 SUSPENSION ARM ASSEMBLY LH

a.
C256611

Loosen the nut on the rear suspension member side.

NOTICE:

Do not remove the nut.



b.
C256605

Remove the bolt, nut and separate the rear shock absorber with coil spring from the rear No. 2 suspension arm assembly LH.


c.
C256610

Remove the bolt, nut and separate the rear axle carrier sub-assembly LH from the rear No. 2 suspension arm assembly LH.


Hide 8.REMOVE REAR SHOCK ABSORBER WITH COIL SPRING

a.
C256606

Remove the 2 nuts and rear shock absorber with coil spring.

NOTICE:

Hold the rear shock absorber with coil spring to prevent it from falling accidentally.