Home › Suspension › REAR SUSPENSION › REAR UPPER ARM
RM2090E _53 Suspension _060681 REAR SUSPENSION _0297606 REAR UPPER ARM G

REAR SUSPENSION  REAR UPPER ARM  INSPECTION  


PROCEDURE

Hide 48790 1.INSPECT REAR UPPER CONTROL ARM ASSEMBLY LH

a.

Inspect the ball joint of upper control arm assembly.

i.

Turn the stud back and forth.

Standard:

There is no unusual resistance or play.



ii.

If there is any unusual resistance or play, replace the upper control arm assembly LH with a new one.



b.

Inspect the dust cover of upper control arm assembly.

i.

Check that the dust cover is not cracked and that there is no grease on it.


ii.

If the dust cover is fissured or grease is leaked, replace the upper control arm assembly LH with a new one.