Home › Suspension › REAR SUSPENSION › TOE CONTROL LINK
RM2090E _53 Suspension _060681 REAR SUSPENSION _0297608 TOE CONTROL LINK G

REAR SUSPENSION  TOE CONTROL LINK  INSPECTION  


PROCEDURE

Hide 48706B 1.INSPECT TOE CONTROL LINK SUB-ASSEMBLY LH

a.

Inspect the ball joint.

i.
G033364

Temporarily install the attaching nut to the stud of the toe control link sub-assembly LH.


ii.

Turn the stud back and forth.

Standard:

There is no unusual resistance or play.



iii.

If there is unusual resistance or play, replace the toe control link sub-assembly LH with a new one.



b.

Inspect the dust cover.

i.

Check that the dust cover is not cracked and that there is no grease on it.


ii.

If the dust cover is fissured or grease is leaked, replace the toe control link sub-assembly LH with a new one.