Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › from 2014.05
RM2090E _53 Suspension _060682 TIRE PRESSURE MONITORING _0297611 TIRE PRESSURE WARNING SYSTEM U

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  TERMINALS OF ECU  


CHECK TIRE PRESSURE WARNING ECU AND RECEIVER


HINT:

Inspect the connectors from the back side while the connectors are connected.


U147236E03
4.719,0.865 5.01,1.021 0.292,0.156 10 false H28

a.

Measure the voltage and resistance according to the value(s) in the table below. If the result is not as specified, the ECU may have a malfunction.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
H28-1 (IG) - H28-12 (GND) W - B IG power source Ignition switch ON 11 to 14 V
H28-4 (BRDA) - H28-12 (GND) R - B Output signals Ignition switch ON Pulse generation (see waveform 1)
H28-5 (BPRG) - H28-12 (GND) P - B Input signals Ignition switch ON Pulse generation (see waveform 1)
H28-7 (+B) - H28-12 (GND) Y-R - B Power Supply Always 11 to 14 V
H28-12 (GND) - Body ground B - Body ground Ground Always Below 1 Ω


b.
C240058E08
2.865,1.219 3.104,1.427 0.24,0.208 10 false *b 0.052,0.063 0.26,0.281 0.208,0.219 10 false *a

Using an oscilloscope, check waveform 1.

Text in Illustration
*a Example
*b GND

Waveform 1:
Item Contents
Terminal H28-4 (BRDA) - H28-12 (GND)
H28-5 (BPRG) - H28-12 (GND)
Tool setting 5 V/DIV, 50 μs./DIV.
Vehicle condition Ignition switch ON

HINT:

The waveform shown in the illustration is an example. If the tester displays a waveform that alternates between high and low, where high is a voltage that is between the IG power source voltage and a voltage 2.2 V lower than the IG power source voltage, and where low is a voltage of between 0 and 1.2 V, the ECU can be judged normal.