Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING VALVE › from 2014.05
RM2090E _53 Suspension _060682 TIRE PRESSURE MONITORING _0297613 TIRE PRESSURE WARNING VALVE A

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING VALVE  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.REMOVE REAR WHEEL

Hide 42607 3.REMOVE TIRE PRESSURE WARNING VALVE AND TRANSMITTER

a.

Remove the cap and valve core to release the air from the tire.

NOTICE:

Keep the removed cap.



b.

After ensuring that a sufficient amount of air has been released, remove the nut and washer used to secure the tire pressure warning valve and transmitter. Drop the tire pressure warning valve and transmitter with the grommet into the tire.

HINT:

The grommet may remain attached to the rim.



c.
C180021E02
2.041,1.737 2.265,1.902 0.224,0.165 10 (A) 2.922,0.912 2.429,0.912 false 0.365,0.83 0.984,0.83 false 0.168,0.741 0.319,0.920 0.151,0.179 10 *1 2.953,0.833 3.120,0.990 0.167,0.158 10 *2

After dropping the tire pressure warning valve and transmitter into the tire, disengage the bead using the shoe of a tire remover.

Text in Illustration
*1 Tire
*2 Shoe

NOTICE:
·

Be careful not to damage the tire pressure warning valve and transmitter due to interference between the valve and the tire bead.

·

Set the tire remover shoe as shown in the illustration.

Width (A):

10 to 20 mm (0.394 to 0.787 in.)





d.

Separate the upper bead.


e.

Take out the tire pressure warning valve and transmitter with the grommet from the tire and separate the lower bead.


f.

Remove the grommet from the tire pressure warning valve and transmitter.