Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RESET SWITCH › from 2014.05
RM2090E _53 Suspension _060682 TIRE PRESSURE MONITORING _0297614 TIRE PRESSURE WARNING RESET SWITCH G

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING RESET SWITCH  INSPECTION  


CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the LHD and RHD vehicles.


PROCEDURE

Hide 84840D 1.INSPECT TIRE PRESSURE WARNING RESET SWITCH

a.
B370504E01
0.124,0.096 0.347,0.304 0.223,0.208 10 *a

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
6 - 3 Pushed (ON) Below 1 Ω
6 - 3 Not pushed (OFF) 10 kΩ or higher



b.

Apply battery voltage between the terminals of the light, and check the operation of the light.

OK:
Tester Condition Specified Condition
Battery positive (+) → terminal 5
Battery negative (-) → terminal 4
LED illuminate


Text in Illustration
*a Component without harness connected
(Tire Pressure Warning Reset Switch)

If the result is not as specified, replace the tire pressure warning reset switch.