Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM
RM2090E _54 Brake _060684 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0297617 VEHICLE STABILITY CONTROL SYSTEM D

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  CALIBRATION  


DESCRIPTION


a.

Refer to the table below and then perform the necessary operation according to the part to be replaced in order to perform calibration.

Parts to be Replaced Necessary Operation
Skid control ECU (Brake actuator assembly)
1.

Perform VSC sensor neutral memorization


Steering sensor
Steering column assembly
Rack and pinion power steering gear assembly
Wheel alignment adjustment



VSC SENSOR NEUTRAL MEMORIZATION


a.

Perform VSC Sensor Neutral Memorization.

NOTICE:
·

While obtaining the zero point, keep the vehicle stationary and do not vibrate, tilt, move, or shake it. (Do not start the engine.)

·

Be sure to perform this procedure on a level surface (with an inclination of less than 1 degree).



HINT:

When VSC sensor neutral memorization is performed, the yaw rate and acceleration sensor and the steering sensor zero point calibration are performed at the same time.


i.

Turn the ignition switch off.


ii.

Check that the steering wheel is centered.


iii.

Check that the shift lever is in neutral.


iv.

Apply the parking brake by pulling up the parking brake lever.


v.

Connect the GTS to the DLC3.


vi.

Turn the ignition switch on.


vii.

Turn the GTS on.


viii.

Enter the following menus: Chassis / ABS/VSC/TRC / Utility / VSC Sensor Neutral Memorization.


ix.

According to the display on the GTS, perform VSC sensor neutral memorization.


x.

Turn the ignition switch off and disconnect the GTS.