Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › 2012.03–2016.06
RM2090E _54 Brake _060684 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0297617 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  U0073  Control Module Communication Bus "A" Off  U0100  Lost Communication with ECM / PCM "A"  U0101  Lost Communication with TCM  U0126  Lost Communication with Steering Angle Sensor Module  


DESCRIPTION

The skid control ECU (brake actuator assembly) receives signals from the ECM, steering sensor and TCM via the CAN communication system.

DTC No. DTC Detection Condition Trouble Area
U0073 The +BS terminal voltage is between 9.6 and 16.5 V and bus off is judged for 0.1 seconds or more. CAN communication system
U0100 The +BS terminal voltage is between 9.6 and 16.5 V, the vehicle speed is 6 km/h (4 mph) or more, and signals cannot be sent to the ECM for 0.5 seconds or more.
·

CAN communication system

·

Skid control ECU

·

ECM


U0123 The +BS terminal voltage is between 9.6 and 16.5 V, the vehicle speed is 6 km/h (4 mph) or more, and signals cannot be sent to the TCM for 0.5 seconds or more.
·

CAN communication system

·

Skid control ECU

·

TCM


U0126 The +BS terminal voltage is between 9.6 and 16.5 V, the vehicle speed is 6 km/h (4 mph) or more, and signals from the steering sensor cannot be received for 0.1 seconds or more.
·

CAN communication system

·

Skid control ECU

·

steering sensor



PROCEDURE

1.RECONFIRM DTC

b.

Turn the ignition switch off.


c.

Start the engine.


d.

Drive the vehicle at a speed of 15 km/h (9 mph) or more and turn the steering wheel to the right and left.


e.

Check that no CAN communication system DTC is output (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM).


f.

If VSC system DTCs are output, record them (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC is not output. A
DTC is output. B
CAN communication system DTC is output. C


HINT:

The CAN communication system must be normal when performing troubleshooting for sensor DTCs (for VSC system).




A

B

C