The skid control ECU (brake actuator assembly) receives signals from the ECM, steering sensor and TCM via the CAN communication system.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0073 | The +BS terminal voltage is between 9.6 and 16.5 V and bus off is judged for 0.1 seconds or more. | CAN communication system |
| U0100 | The +BS terminal voltage is between 9.6 and 16.5 V, the vehicle speed is 6 km/h (4 mph) or more, and signals cannot be sent to the ECM for 0.5 seconds or more. | ·
CAN communication system ·
Skid control ECU ·
ECM |
| U0123 | The +BS terminal voltage is between 9.6 and 16.5 V, the vehicle speed is 6 km/h (4 mph) or more, and signals cannot be sent to the TCM for 0.5 seconds or more. | ·
CAN communication system ·
Skid control ECU ·
TCM |
| U0126 | The +BS terminal voltage is between 9.6 and 16.5 V, the vehicle speed is 6 km/h (4 mph) or more, and signals from the steering sensor cannot be received for 0.1 seconds or more. | ·
CAN communication system ·
Skid control ECU ·
steering sensor |
| U0140 | The +BS terminal voltage is between 9.6 and 16.5 V, the vehicle is being driven, and signals from the steering sensor cannot be received for 0.5 seconds or more. | ·
CAN communication system ·
Skid control ECU ·
Main body ECU (Network gateway ECU) |
Clear the DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
Turn the ignition switch off.
Start the engine.
Drive the vehicle at a speed of 15 km/h (9 mph) or more and turn the steering wheel to the right and left.
Check that no CAN communication system DTC is output (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM).
If VSC system DTCs are output, record them (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output. | A |
| DTC is output. | B |
| CAN communication system DTC is output. | C |
The CAN communication system must be normal when performing troubleshooting for sensor DTCs (for VSC system).
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C
(See pagePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)