Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR
RM2090E _54 Brake _060684 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0297618 BRAKE ACTUATOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE ACTUATOR  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL SKID CONTROL ECU

a.

Install a new skid control ECU so that the coils of the skid control ECU and the brake actuator valves are aligned.

NOTICE:
·

Install the skid control ECU while keeping it level by holding at the corners to prevent deformation of the skid control ECU housing cover.

·

Check that there is no dirt or foreign matter on the installation surface.




b.

Tighten the screws on the skid control ECU using the following procedure.

NOTICE:

As the screws are not reusable, be sure to use new screws.


i.
C389932E01
1.573,1.958 1.813,2.146 0.24,0.188 10 false 1 2.74,3.188 2.979,3.375 0.24,0.188 10 false 2 2.625,1.938 2.865,2.125 0.24,0.188 10 false 3 1.438,3.208 1.677,3.396 0.24,0.188 10 false 4

Using a TORX deep socket wrench E5, tighten new 4 screws in the order shown in the illustration.

Torque:
1.5 N*m (15 kgf*cm, 13 in.*lbf)


ii.

Check that there is no foreign matter caught between the skid control ECU and the brake actuator.


iii.

Tighten the 4 screws again in the order shown in the illustration.

Torque:
3.0 N*m (31 kgf*cm, 27 in.*lbf)


iv.

Check that there is no gap between the skid control ECU and the brake actuator.



Hide 44599A 2.INSTALL BRAKE ACTUATOR DAMPER

a.
C261003E01
2.057,0.121 2.185,0.280 0.128,0.158 10 A 2.446,1.857 2.575,2.016 0.128,0.158 10 B 1.793,2.213 1.921,2.371 0.128,0.158 10 B

Install the 3 new brake actuator dampers (A and B) to the brake actuator bracket assembly.


Hide 44590 3.INSTALL BRAKE ACTUATOR BRACKET ASSEMBLY

C261002

a.

Install the brake actuator bracket assembly to the brake actuator assembly with the 3 new nuts and 3 new washers.

NOTICE:

Do not remove the hole plugs of a new brake actuator assembly before connecting the brake lines because the brake actuator assembly is filled with brake fluid.


Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)