Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR
RM2090E _54 Brake _060684 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0297620 REAR SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  REAR SPEED SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

The procedures listed below are for the LH side.

·

Use the same procedures for the RH and LH sides.



PROCEDURE

Hide 89546 1.INSTALL REAR SPEED SENSOR LH

a.

Install the rear speed sensor LH with the 3 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

NOTICE:

Prevent foreign matter from attaching to the rear speed sensor LH tip, installation surface and sensor body.



b.

Connect the 2 harness clamps.

NOTICE:

Do not twist the wire harness for the rear speed sensor LH when installing it.



c.

Pull the rear speed sensor LH grommet out from vehicle interior.

NOTICE:
·

Do not pull the rear speed sensor LH wire harness.

·

Do not fix the pass-through grommet at an angle.




d.

Connect the rear speed sensor LH connector.


e.

Install the luggage compartment floor mat.


Hide 2.INSTALL REAR WHEEL LH

Torque:
120 N*m (1224 kgf*cm, 89 ft.*lbf)