Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VSC OFF SWITCH › from 2016.06
RM2090E _54 Brake _060684 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0297622 VSC OFF SWITCH G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VSC OFF SWITCH  INSPECTION  


PROCEDURE

Hide 84720J 1.INSPECT PATTERN SELECT SWITCH ASSEMBLY

a.

Make sure that there is no looseness in the locking part and the connecting part of the VSC OFF switch.

i.
C257499E01
0.034,0.01 0.218,0.175 0.184,0.165 10 *a

Measure the resistance according to the value(s) in the table below.

Text in Illustration
*a Component without harness connected
(Pattern Select Switch Assembly)

Standard Resistance:
Tester Connection Check Condition Specified Condition
5 - 8 Switch not pushed in 10 kΩ or higher
Switch pushed in Below 1 Ω




b.

Make sure that there is no looseness in the locking part and the connecting part of the TRACK switch.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Check Condition Specified Condition
1 - 8 Switch not pushed in 10 kΩ or higher
Switch pushed in Below 1 Ω




c.

Check the illumination status

i.

Check the illumination when the battery voltage is applied between the connector terminals.

Standard:
Check Condition Specified Condition
Battery positive → 2
Battery negative → 3
The illumination comes on