Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER(for RHD)
RM2090E _54 Brake _060685 BRAKE SYSTEM (OTHER) _0297625 BRAKE MASTER CYLINDER(for RHD) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(for RHD)  INSTALLATION  


PROCEDURE

Hide 04493 1.INSTALL SEAL

a.

Install a new seal to the brake master cylinder sub-assembly.


Hide 47201 2.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY

a.

Install the brake master cylinder sub-assembly to the brake booster assembly with the 2 nuts.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


b.

Engage the 2 harness clamp.


c.

Using a union nut wrench 12, connect the 2 brake lines and install the brake master cylinder to way tube to the brake master cylinder sub-assembly.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



d.

Connect the reservoir level switch connector.


Hide 3.BLEED BRAKE SYSTEM

Hide 53607 4.INSTALL FRONT SUSPENSION UPPER TO COWL BRACE SUB-ASSEMBLY RH

Hide 5.INSTALL FRONT WHEEL RH

Torque:
120 N*m (1224 kgf*cm, 86 ft.*lbf)