Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP
RM2090E _54 Brake _060685 BRAKE SYSTEM (OTHER) _0297632 VACUUM PUMP A

BRAKE SYSTEM (OTHER)  VACUUM PUMP  INSTALLATION  


PROCEDURE

Hide 29300 1.INSTALL VACUUM PUMP ASSEMBLY

a.

Coat a new O-ring with engine oil, and install it.


b.
A279600E05
2.635,1.229 2.917,1.729 true 1.917,0.156 2.292,0.396 0.375,0.24 10 false A - A 0.99,0.583 1.365,0.823 0.375,0.24 10 false A 0.99,1.885 1.26,2.052 0.271,0.167 10 false A 2.51,0.365 2.677,0.521 0.167,0.156 10 false *b 2.167,1.427 2.333,1.583 0.167,0.156 10 false *c 2.948,1.75 3.323,1.99 0.375,0.24 10 false *a

Apply seal packing in a continuous line as shown in the illustration.

Text in Illustration
*a Edge of Groove
*b 2.0 to 4.0 mm (0.078 to 0.158 in.) in Diameter
*c 1.0mm or Less

NOTICE:
·

Clean and degrease the contact surface.

·

Install the vacuum pump assembly within 5 minutes of applying seal packing.



HINT:

When replace the vacuum pump assembly on the vehicle, apply seal packing to the vacuum pump assembly.



c.
C262998E02
1.677,-0.021 1.677,2.177 false 0.781,0.917 1.271,0.635 1.271,0.635 0.802,1.365 true 2.76,0.677 3.188,0.438 3.188,0.438 2.75,1.094 true 1.281,0.49 1.448,0.646 0.167,0.156 10 false *a 3.177,0.281 3.344,0.438 0.167,0.156 10 false *b

Install the vacuum pump assembly while aligning the grooves of the vacuum pump assembly with the claws of the intake camshaft RH.

Text in Illustration
*a Groove of the Vacuum Pump Assembly
*b Claw of the Intake Camshaft

NOTICE:

Make sure that the O-ring is not pinched.



d.

Install the 3 bolts.

Torque:
16 N*m (163 kgf*cm, 12 ft.*lbf)


Hide 44771 2.INSTALL VACUUM TUBE CONNECTOR HOSE

a.

Install the vacuum tube connector hose.


Hide 53607 3.INSTALL FRONT SUSPENSION UPPER TO COWL BRACE SUB-ASSEMBLY RH