Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP
RM2090E _54 Brake _060685 BRAKE SYSTEM (OTHER) _0297632 VACUUM PUMP G

BRAKE SYSTEM (OTHER)  VACUUM PUMP  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 29300 1.INSPECT VACUUM PUMP ASSEMBLY OPERATION

a.
C260988

Move the clamp and disconnect the vacuum tube connector hose from the vacuum pump assembly.


b.
C260989E02
0.615,0.177 1.177,0.146 false 1.198,0.052 1.396,0.219 0.198,0.167 10 false *1

Connect the hose of a vacuum gauge to the vacuum pump assembly.

Text in Illustration
*1 Vacuum Gauge


c.

Start the engine and warm it up for more than 2 minutes.


d.

With the engine idling, check the vacuum of the vacuum pump assembly.

Standard pressure:

More than 93 kPa (698 mmHg, 27 in.Hg) of vacuum


If the is not as specified, disassemble the vacuum pump assembly and inspect or replace it (See page Brake>BRAKE SYSTEM (OTHER)>VACUUM PUMP>REMOVAL).

HINT:

After disassembling and checking the vacuum pump assembly, check the vacuum pump assembly function.



e.

Remove the vacuum gauge from the vacuum pump assembly.


f.

Connect the vacuum tube connector hose to the vacuum pump and move the clamp back into position.