1.REMOVE CYLINDER BOOT
Remove the 2 cylinder boots.
To prevent damage to the front disc brake piston, remove the boot by hand, and not using a screwdriver or the like.
| *1 | Cylinder Boot |
| *2 | Front Disc Brake Piston |
47731
2.REMOVE FRONT DISC BRAKE PISTON
Place a wooden block between the front disc brake piston and disc cylinder.
| *1 | Wooden Block |
| *a | 30 mm (1.811 in.) |
Slowly apply compressed air to remove the 2 front disc brake pistons from the cylinder.
Do not place your fingers in front of the front disc brake piston when applying compressed air.
Do not spatter the brake fluid.
If the front disc brake piston has been damaged, replace it with a new one.
Remove the wooden block.
3.REMOVE PISTON SEAL
Using a screwdriver with its tip wrapped in protective tape, remove the 2 piston seals from the disc brake cylinder.
| *1 | Protective Tape |
Do not damage the inner surface or piston seal groove of the cylinder.
31478B
4.REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP
Remove the front disc brake bleeder plug cap from the front disc brake bleeder plug.
47547B
5.REMOVE FRONT DISC BRAKE BLEEDER PLUG
Remove the front disc brake bleeder plug.