Home › Brake › BRAKE (FRONT) › FRONT BRAKE FLEXIBLE HOSE
RM2090E _54 Brake _060686 BRAKE (FRONT) _0297634 FRONT BRAKE FLEXIBLE HOSE A

BRAKE (FRONT)  FRONT BRAKE FLEXIBLE HOSE  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RH and LH sides.

·

The procedure listed below is for LH side.



PROCEDURE

Hide 47313A 1.INSTALL NO. 1 FRONT FLEXIBLE HOSE

a.

Temporarily install the NO. 1 front flexible hose with a new clip.

NOTICE:

Securely install the clip.



b.

Hold the NO. 1 front flexible hose with a wrench using a union nut wrench.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not bend or damage the brake tube.

·

Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.

·

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).




c.

Connect the No. 1 front flexible hose to the front shock absorber assembly with the bolt.

Torque:
33 N*m (337 kgf*cm, 24 ft.*lbf)


d.

Install the No. 1 flexible hose to the disc brake cylinder assembly with 2 new gaskets and the new union bolt.

Torque:
26 N*m (265 kgf*cm, 19 ft.*lbf)


Hide 4.INSPECT BRAKE FLUID LEAK

Hide 6.INSTALL FRONT WHEEL

Torque:
120 N*m (1224 kgf*cm, 89 ft.*lbf)