Home › Brake › BRAKE (REAR) › REAR BRAKE (for Floating Type Caliper)
RM2090E _54 Brake _060687 BRAKE (REAR) _0297635 REAR BRAKE A

BRAKE (REAR)  REAR BRAKE  DISASSEMBLY  


CAUTION / NOTICE / HINT

PROCEDURE

Hide 47731B 1.REMOVE REAR DISC BRAKE PISTON

a.
C256666E03
2.74,1.219 2.74,0.813 false 2.667,0.625 2.844,0.813 0.177,0.188 10 false *1 2.677,2.76 2.854,2.948 0.177,0.188 10 false *a

Place a wooden block between the rear disc brake piston and disc brake cylinder.

Text in Illustration
*1 Wooden Block
*a 30 mm (1.1811 in.)


b.

Slowly apply compressed air to remove the disc brake piston.

CAUTION:

Do not place your fingers in front of the piston when using compressed air.


NOTICE:

Do not spatter brake fluid.



Hide 2.REMOVE CYLINDER BOOT

a.
C256668E01
0.972,0.347 1.224,0.581 0.252,0.234 10 *1 1.177,0.45 1.555,0.766 false

Using a screwdriver with its tip wrapped in protective tape, remove the cylinder boot from the disc brake cylinder.

NOTICE:

Do not damage the inner surface or groove of the cylinder.


Text in Illustration
*1 Protective Tape


Hide 3.REMOVE PISTON SEAL

a.
C256667E02
1.635,0.51 1.177,1.01 true 1.667,0.365 1.844,0.542 0.177,0.177 10 false *1

Using a screwdriver with its tip wrapped in protective tape, remove the piston seal.

Text in Illustration
*1 Protective Tape

NOTICE:

Do not damage the inner surface or piston seal groove of the cylinder.



Hide 31478C 4.REMOVE REAR DISC BRAKE BLEEDER PLUG CAP

a.

Remove the rear disc brake bleeder plug cap from the rear disc brake bleeder plug.


Hide 47547C 5.REMOVE REAR DISC BRAKE BLEEDER PLUG

a.

Remove the rear disc brake bleeder plug from the rear disc brake cylinder assembly LH.