Home › Brake › BRAKE (REAR) › REAR BRAKE (for Floating Type Caliper)
RM2090E _54 Brake _060687 BRAKE (REAR) _0297635 REAR BRAKE A

BRAKE (REAR)  REAR BRAKE  REASSEMBLY  


CAUTION / NOTICE / HINT

PROCEDURE

Hide 47547C 1.TEMPORARILY INSTALL REAR DISC BRAKE BLEEDER PLUG

a.

Temporarily install the rear disc brake bleeder plug to the rear disc brake cylinder LH.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 31478C 2.INSTALL REAR DISC BRAKE BLEEDER PLUG CAP

a.

Install the rear disc brake bleeder plug cap to the rear disc brake bleeder plug.


Hide 3.INSTALL PISTON SEAL

a.
C219154

Apply a light layer of lithium soap base glycol grease to the entire circumference of a new piston seal and install it into the groove of the disc brake cylinder.

Text in Illustration
V100144

Lithium Soap Base Glycol Grease


Hide 4.INSTALL CYLINDER BOOT

a.
C262307E03
0.917,0.354 1.292,0.354 false 2.302,1.052 2.677,1.052 false 1.208,2.615 1.208,2.302 1.208,2.302 1.479,2.302 false 1.729,3.688 2.229,3.688 false 2.271,3.573 2.5,3.802 0.229,0.229 10 false *2 2.719,0.958 2.948,1.188 0.229,0.229 10 false *2 1.531,2.198 1.76,2.427 0.229,0.229 10 false *1 1.313,0.271 1.542,0.5 0.229,0.229 10 false *1

Apply a light layer of lithium soap base glycol grease to a new cylinder boot, and put it on the disc brake piston as shown in the illustration.

Text in Illustration
*1 Piston
*2 Cylinder Boot
V100144

Lithium soap base glycol grease


Hide 47731B 5.INSTALL REAR DISC BRAKE PISTON

a.
C256670E03
1.135,0.844 1.479,0.844 false 1.125,1.323 1.406,1.323 false 1.135,2.24 1.729,2.24 1.729,2.24 1.729,2.083 false 0.969,2.156 1.146,2.333 0.177,0.177 10 false *3 0.948,1.229 1.125,1.406 0.177,0.177 10 false *2 0.969,0.781 1.146,0.958 0.177,0.177 10 false *1

Fit the seal section of the cylinder boot into the groove of the rear disc brake cylinder assembly LH.

Text in Illustration
*1 Cylinder Boot
*2 Rear disc Brake Piston
*3 Rear disc Brake Cylinder Assembly LH

NOTICE:

Securely fit the seal section of the cylinder boot.



b.

Push in the piston by hand and fit the seal section of the boot into the groove of the rear disc brake piston.

NOTICE:

Securely fit the seal section of the cylinder boot.