Home › Brake › BRAKE (REAR) › REAR BRAKE FLEXIBLE HOSE
RM2090E _54 Brake _060687 BRAKE (REAR) _0297636 REAR BRAKE FLEXIBLE HOSE A

BRAKE (REAR)  REAR BRAKE FLEXIBLE HOSE  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RH and LH sides.

·

The procedure listed below is for LH side.



PROCEDURE

Hide 47319F 1.INSTALL REAR LEFT FLEXIBLE HOSE

a.

Connect the rear left flexible hose with a new clip.

NOTICE:

Securely install the clip.



b.

Hold the rear left flexible hose with a wrench and connect the brake tube to the rear left flexible hose using a union nut wrench.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not bend or damage the brake tube.

·

Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting position.

·

Use the formula to calculate special torque wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).




c.

Connect the rear left flexible hose to the rear carrier LH with the bolt.

Torque:
33 N*m (337 kgf*cm, 24 ft.*lbf)


d.

Connect the rear left flexible hose to the rear disc brake cylinder assembly LH with 2 new gaskets and a new union bolt.

Torque:
26 N*m (265 kgf*cm, 19 ft.*lbf)


Hide 4.INSPECT BRAKE FLUID LEAK

Hide 6.INSTALL REAR WHEEL

Torque:
120 N*m (1224 kgf*cm, 88 ft.*lbf)