The power steering ECU assembly receives signals from the ECM and skid control ECU (brake actuator assembly) via the CAN communication system.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0100 | Lost communication with the ECM/PCM "A" | ·
CAN communication system ·
ECM |
| U0122 | Lost communication with the brake system control module | ·
CAN communication system ·
Skid control ECU (Brake actuator assembly) |
| U0416 | The brake system control module signal malfunction |
Clear the DTC(s) (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).
DTC is not output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
(See pagePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)