Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM2090E _55 Steering _060689 POWER ASSIST SYSTEMS _0297642 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1521  Motor Circuit Malfunction  C1531  ECU Malfunction  C1532  ECU Malfunction  C1533  ECU Malfunction  C1534  ECU Malfunction  C1554  Power Supply Relay Failure  


DESCRIPTION

If the power steering ECU assembly stores these DTCs, it will shut off the power supply relay circuit (built into the power steering ECU assembly) and stop power assist. However, power assist continues if DTC C1533 or C1534 is stored.

DTC Code DTC Detection Condition Trouble Area
C1521 Motor overcurrent Power steering ECU assembly
C1531 An ECU internal malfunction (CPU malfunction)
C1532 An ECU internal malfunction (peripheral circuit malfunction)
C1533 An ECU internal malfunction (substrate temperature sensor malfunction)
C1534 An ECU internal malfunction (EEPROM error)
C1554 A power supply relay circuit malfunction

CAUTION / NOTICE / HINT

NOTICE:

If the power steering ECU assembly is replaced with a new one, perform rotation angle sensor initialization and torque sensor zero point calibration (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK FOR DTC

b.

Check for DTCs (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output. A
DTC is output. B



A

B

REPLACE POWER STEERING ECU ASSEMBLY