The power steering ECU assembly receives vehicle speed signals from the skid control ECU via CAN communication. The power steering ECU assembly provides appropriate assisting force in accordance with the vehicle speed, based on the signals.
If the power steering ECU assembly stores this DTC, it adjusts the amount of power assist to the amount provided for a speed of 100 km/h (62 mph) and continues the system control.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1541 | The vehicle speed signals malfunction | ·
Speed sensor circuit ·
Skid control ECU ·
CAN communication system ·
Power steering ECU assembly |
If the power steering ECU assembly is replaced with a new one, perform rotation angle sensor initialization and torque sensor zero point calibration (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).
Check if DTC U0416 is output (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC U0416 is not output. | A |
| DTC U0416 is output. | B |
DTC U0416 indicates a skid control ECU communication malfunction in the power steering system.
A
B
(See pagePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
Using the GTS, check for DTCs and confirm that there are no problems in the brake control system (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output. | A |
| DTC is output. | B |
A
B