Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM2090E _55 Steering _060689 POWER ASSIST SYSTEMS _0297642 POWER STEERING SYSTEM G

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1. CHECK STEERING EFFORT (TORQUE)

NOTICE:

Some of these service operations may affect the SRS airbags. Read the precautionary notices concerning the SRS airbag system before servicing.


a.

Stop the vehicle on a level, paved surface and align the wheels straight ahead.


b.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.




d.

Connect the cable to the negative (-) battery terminal.


e.

Using a torque wrench, check that the steering wheel set nut is properly tightened.

Torque:
39 N*m (398 kgf*cm, 29 ft.*lbf)


f.

Start the engine.


g.

Turn the steering wheel 90 degrees to the right and check the steering effort (torque) while continuing to turn it further in the same direction.

Standard steering effort (Reference):

6.0 N*m (61 kgf*cm, 53 in.*lbf) or less



h.

Align the front wheels facing straight ahead.


i.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.




k.

Connect the cable to the negative (-) battery terminal.