Home › Steering › STEERING COLUMN › STEERING WHEEL › 2012.03–2016.06
RM2090E _55 Steering _060690 STEERING COLUMN _0297647 STEERING WHEEL A

STEERING COLUMN  STEERING WHEEL  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

Do not replace the spiral cable with the battery connected and the ignition switch ON.

·

Do not rotate the spiral cable without the steering wheel with the battery connected and the ignition switch ON.

·

Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

The power window system utilizes a mechanism that the door glass moves down slightly when the door is opened, and that the glass moves up when closing the door in order to prevent the door molding from being damaged. When the battery negative (-) terminal needs to be disconnected for servicing, fully open the driver and passenger door glasses in advance.


Hide 3.ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

Hide 45111 5.REMOVE STEERING WHEEL ASSEMBLY

a.
C260489E02
0.885,0.646 1.25,0.469 1.25,0.469 0.896,0.479 true 1.271,0.385 1.521,0.604 0.25,0.219 10 false *1

Remove the steering wheel assembly set nut.

Text in Illustration
*1 Matchmark


b.

Put matchmarks on the steering wheel assembly and steering main shaft.


c.

Disconnect the connectors from the spiral cable sub-assembly and steering wheel assembly.


d.
C260490E02
1.771,1.969 2.583,2.969 true 2.74,1.115 2.979,1.313 0.24,0.198 10 false *a 0.927,2.552 1.167,2.75 0.24,0.198 10 false *b 2.635,2.969 2.948,3.167 0.313,0.198 10 false SST

Using SST, remove the steering wheel assembly.

Text in Illustration
*a Turn
*b Hold

SST
09950-50013  (09951-05010, 09952-05010, 09953-05020, 09954-05031)

NOTICE:

Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.



Hide 84610F 6.REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) (for Automatic Transmission)

Hide 45713A 7.REMOVE STEERING SHAKE DAMPER

a.
C257762

Remove the 2 screws and steering shake damper from steering wheel assembly.


Hide 45184 8.REMOVE LOWER STEERING WHEEL BOSS COVER (w/ Cruise Control System)

Hide 45184 9.REMOVE LOWER STEERING WHEEL BOSS COVER (w/o Cruise Control System)

a.
C263659

Remove the 2 screws.


b.

Disengage the 2 claws and remove the lower steering wheel boss cover.


Hide 45116 10.REMOVE NO. 1 STEERING WHEEL ORNAMENT

a.
C260491

Disengage the 2 claws and guide to remove the No. 1 steering wheel ornament.