84250A
1.INSPECT STEERING PAD SWITCH ASSEMBLY
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected
(Steering Pad Switch Assembly) |
*b | VOL+ |
| *c | VOL- | *d | MODE |
| *e | SEEK+ | *f | SEEK- |
| *g | ENTER | *h | UP |
| *i | DOWN | *j | LEFT |
| *k | RIGHT | *l | BACK |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| z9-6 (AU1) - z9-5 (AU-GND) | No switch pushed | 98 to 102 kΩ |
| VOL+ switch pushed | Below 2.5 Ω | |
| VOL- switch pushed | 322 to 336 Ω | |
| SEEK+ switch pushed | 980 to 1020 Ω | |
| SEEK- switch pushed | 3048 to 3172 Ω | |
| z9-2 (DP) - z9-4 (EAU) | No switch pushed | 98 to 102 kΩ |
| LEFT switch pushed | Below 2.5 Ω | |
| UP switch pushed | 322 to 336 Ω | |
| DOWN switch pushed | 980 to 1020 Ω | |
| RIGHT switch pushed | 3048 to 3172 Ω | |
| z9-1 (AU2) - z9-5 (AUGND) | No switch pushed | 98 to 102 kΩ |
| MODE switch pushed | Below 2.5 Ω | |
| z9-3 (DP2) - z9-4 (EAU) | No switch pushed | 98 to 102 kΩ |
| ENTER switch pushed | Below 2.5 Ω | |
| BACK switch pushed | 980 to 1020 Ω | |
| z9-12 (HO) - A-1 (HO) | Always | Below 2.5 Ω |
| z9-10 (ECC) - B-1 (ECC)* | Always | Below 2.5 Ω |
| z9-11 (ECC) - B-3 (ECC)* | Always | Below 2.5 Ω |
*: w/ Cruise Control System
If the result is not as specified, replace the steering pad switch assembly.
Check the illumination.
Connect a positive (+) lead from the battery to the terminal z9-8 (ILL+) and a negative (-) lead to the terminal z9-9 (ILL-) of the steering pad switch assembly connector.
Check that the switch illumination illuminates.
The steering pad switch illumination illuminates.
If the result is not as specified, replace the steering pad switch assembly.