44250
1.SECURE RACK AND PINION POWER STEERING GEAR ASSEMBLY
Using SST, secure the rack and pinion power steering gear assembly in a vise.
| *1 | Protective Tape |
Tape SST before use.
45047
2.REMOVE TIE ROD END SUB-ASSEMBLY LH
Put matchmarks on the tie rod end sub-assembly LH and the steering rack end sub-assembly.
| *1 | Matchmark |
Remove the tie rod end sub-assembly LH and lock nut.
45046
3.REMOVE TIE ROD END SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
45535B
4.REMOVE STEERING RACK BOOT CLIP
Use the same procedure for both the LH side and RH side.
Using pliers, remove the steering rack boot clip.
45535D
5.REMOVE NO. 1 STEERING RACK BOOT CLAMP
Use the same procedure for both the LH side and RH side.
Using a screwdriver, remove the No. 1 steering rack boot clamp.
Be careful not to damage the No. 1 steering rack boot.
45535
6.REMOVE NO. 1 STEERING RACK BOOT
If the No. 1 steering rack boot is fissured, damaged or deteriorated, replace it with a new one.
Use the same procedure for both the LH side and RH side.
45503
7.REMOVE STEERING RACK END SUB-ASSEMBLY
Using SST, remove the steering rack end sub-assembly.
| *A | for LHD | - | - |
| *a | LH Side | *b | RH Side |
| *c | Turn | *d | Hold |
Turn SST in the direction as shown in the illustration.
| *A | for RHD | - | - |
| *a | LH Side | *b | RH Side |
| *c | Turn | *d | Hold |
Turn SST in the direction as shown in the illustration.
8.REMOVE STEERING RACK GUIDE
Using SST, remove the lock nut.
Turn SST in the direction as shown in the illustration.
Using SST, remove the steering rack guide spring cap.
Remove the steering rack guide and the steering rack guide spring.