Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › 2012.03–2016.06
RM2090E _56 Audio / Visual / Telematics _060692 AUDIO / VIDEO _0297650 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Illumination Circuit  


DESCRIPTION

Power is supplied to the radio receiver assembly illumination when the light control switch is in the tail or head position.

WIRING DIAGRAM

E249946E02
0.49,0.771 1.302,0.948 0.813,0.177 10 false from Battery 3.396,0.938 3.896,1.115 0.5,0.177 10 false PANEL 2.667,1.469 3.01,1.646 0.344,0.177 10 false TAIL 5.281,0.771 5.563,0.917 0.281,0.146 10 false D14 5.323,0.542 5.521,0.719 0.198,0.177 10 false 10 5.646,0.771 5.958,0.948 0.313,0.177 10 false ILL+ 5.156,2.146 6.802,2.333 1.646,0.188 10 false Radio Receiver Assembly 4.052,1.125 5.542,1.667 1.49,0.542 10 false to Main Body ECU (network gateway ECU)

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuse for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK ILLUMINATION
a.

Check if the illumination for the radio receiver assembly, heater control switch or others (hazard switch, transmission control switch, etc.) comes on when the light control switch is turned to the head or tail position.

Result:
Result Proceed to
Illumination comes on for all components except radio receiver assembly. A
No illumination comes on (radio receiver assembly, hazard switch, heater control switch, etc.). B




A

2.CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)

B

2.CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)
a.

Disconnect the radio receiver assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
D14-10 (ILL+) - Body ground Light control switch in the tail or head position 11 to 14 V




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR