Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM
RM2090E _56 Audio / Visual / Telematics _060692 AUDIO / VIDEO _0297650 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the radio receiver assembly through this circuit.

The sound signal that has been sent is amplified by the radio receiver assembly, and then is sent to the speakers.

If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the radio receiver assembly or speakers.

WIRING DIAGRAM

E249953E02
1.177,0.76 1.594,0.917 0.417,0.156 10 false AUX I 1.26,1.146 1.594,1.302 0.333,0.156 10 false AR I 1.292,2 1.594,2.156 0.302,0.156 10 false AL I 1.177,1.583 1.594,1.74 0.417,0.156 10 false ASGN 1.167,2.417 1.594,2.573 0.427,0.156 10 false AGND 2.458,2.563 3.115,2.865 0.656,0.302 10 false (Shielded) 4.083,2.542 4.729,2.844 0.646,0.302 10 false (Shielded) 5.792,0.729 6.219,0.885 0.427,0.156 10 false AUXI 5.792,1.156 6.219,1.313 0.427,0.156 10 false ARI 5.354,2.854 5.646,3.01 0.292,0.156 10 false D12 5.51,0.646 5.688,0.802 0.177,0.156 10 false 25 5.51,1.063 5.688,1.219 0.177,0.156 10 false 26 5.51,1.906 5.688,2.063 0.177,0.156 10 false 28 5.51,1.479 5.688,1.635 0.177,0.156 10 false 27 5.51,2.313 5.688,2.469 0.177,0.156 10 false 11 1.688,0.646 1.865,0.802 0.177,0.156 10 false 9 1.688,1.052 1.865,1.208 0.177,0.156 10 false 6 1.688,1.896 1.865,2.052 0.177,0.156 10 false 7 1.688,1.479 1.865,1.635 0.177,0.156 10 false 8 1.688,2.313 1.865,2.469 0.177,0.156 10 false 10 0.115,2.813 0.469,2.969 0.354,0.156 10 false a1 0.115,3 2.479,3.302 2.365,0.302 10 false No. 1 Stereo Jack Adapter Asssembly 5.354,3.021 6.885,3.323 1.531,0.302 10 false Radio Receiver Assmbly 5.792,2.01 6.219,2.167 0.427,0.156 10 false ALI 5.792,1.583 6.219,1.74 0.427,0.156 10 false ASGN 5.792,2.427 6.219,2.583 0.427,0.156 10 false AGND

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the No. 1 stereo jack adapter assembly and radio receiver assembly connectors.


b.
U190447E02
2.146,1.573 1.99,1.969 true 2.281,1.573 2.458,1.948 true 2.406,1.573 2.74,1.885 true 2.042,1.573 1.531,2.021 true 2.156,1.365 1.417,0.438 true 1.292,4.073 0.573,4.042 true 2,4.042 2.729,4.01 true 1.635,4.042 1.073,3.74 true 1.5,4.115 1.052,4.292 true 1.813,4.115 2.292,4.292 true 1.531,3.604 1.219,2.552 true 1.719,3.604 2.135,2.615 true 1.708,3.76 2.729,3.594 true 1.375,3.625 0.99,2.958 true 1.885,3.615 2.5,3.104 true 0.188,0.115 0.406,0.292 0.219,0.177 10 false *a 0.188,2.229 0.625,2.406 0.438,0.177 10 false *b 2.385,1.979 2.635,2.135 0.25,0.156 10 false ARI 1.271,2 1.5,2.156 0.229,0.156 10 false ALI 2.792,1.833 3.208,1.99 0.417,0.156 10 false ASGN 1,0.292 1.427,0.448 0.427,0.156 10 false AGND 1.792,2.01 2.135,2.167 0.344,0.156 10 false AUXI 2.781,3.51 3.167,3.667 0.385,0.156 10 false UJSS 0.708,2.417 1.198,2.573 0.49,0.156 10 false USB D- 2.167,2.458 2.688,2.615 0.521,0.156 10 false USB D+ 0.271,1.146 0.552,1.302 0.281,0.156 10 false D12 0.302,3.323 0.479,3.479 0.177,0.156 10 false a1 0.25,3.958 0.552,4.115 0.302,0.156 10 false AR I 0.771,4.271 1.052,4.427 0.281,0.156 10 false AL I 0.625,3.625 1.042,3.781 0.417,0.156 10 false ASGN 2.354,4.271 2.771,4.427 0.417,0.156 10 false AUX I 2.781,3.938 3.198,4.094 0.417,0.156 10 false AGND 0.292,2.823 0.958,2.979 0.667,0.156 10 false USB PWR 2.563,3 3.26,3.156 0.698,0.156 10 false PWR GND

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
a1-9 (AUX I) - D12-25 (AUXI) Always Below 1 Ω
a1-6 (AR I) - D12-26 (ARI) Always Below 1 Ω
a1-7 (AL I) - D12-28 (ALI) Always Below 1 Ω
a1-8 (ASGN) - D12-27 (ASGN) Always Below 1 Ω
a1-10 (AGND) - D12-11 (AGND) Always Below 1 Ω
a1-9 (AUX I) - Body ground Always 10 kΩ or higher
a1-6 (AR I) - Body ground Always 10 kΩ or higher
a1-7 (AL I) - Body ground Always 10 kΩ or higher
a1-8 (ASGN) - Body ground Always 10 kΩ or higher
a1-10 (AGND) - Body ground Always 10 kΩ or higher


Text in Illustration
*a Front view of wire harness connector
(to Radio Receiver Assembly)
*b Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly)



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR