Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
55405B
2.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
3.REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET
Remove the 4 bolts and pull the radio receiver assembly with bracket toward the rear of the vehicle.
Disconnect each connector and remove the radio receiver assembly with bracket.
86211
4.REMOVE NO. 1 RADIO BRACKET
Remove the 4 screws and remove the No. 1 radio bracket from the radio receiver assembly.
86212
5.REMOVE NO. 2 RADIO BRACKET
Use the same procedure as for the No. 1 radio bracket.