Home › Power Source / Network › POWER DISTRIBUTION › BATTERY CURRENT SENSOR › 2012.03–2019.03
RM2090E _57 Power Source / Network _060694 POWER DISTRIBUTION _0297663 BATTERY CURRENT SENSOR A

POWER DISTRIBUTION  BATTERY CURRENT SENSOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

HINT:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with the work (See page General>INTRODUCTION>REPAIR INSTRUCTION>CUSTOMIZE PARAMETERS).


Hide 2.REMOVE BATTERY CURRENT SENSOR ASSEMBLY

a.
E247221

Disconnect the connector.


b.
E247222E01
3.181,0.204 3.365,0.377 0.185,0.172 10 *1 2.336,1.569 3.218,0.363 false

Remove the nut and disconnect the engine wire.

NOTICE:

Since this operation may damage the molding, make sure to fully open the driver and passenger side door windows.


Text in Illustration
*1 Engine Wire


c.
E247223

Loosen the nut and remove the battery current sensor assembly.